The Derringer™ |
THIS ITEM IS IN PRODUCTION, PLEASE VISIT OUR FAQ PAGE FOR CURRENT BUILD TIMES.
Please visit our FAQ page prior to ordering for current build time, payment information and other answers you may need.
Please contact us prior to ordering if you have any special requests.

The Derringer™ has four pockets, and five accessory mounts. The design is based on the Original High Caliber Holster™. The straps are the same, but the base is approximately one third the height of the Original and the Ricochet™. The first pocket is our signature fast draw playing card pocket. The fast draw pocket allows you to draw and reholster your playing cards even faster than our previous generation card holders. The Derringer™ also has a very accommodating 4" x 2" x 1" (102mm x 51mm x 26mm) pouch, perfect for any close-up props you may carry. The pouch also doubles as a second playing card holder if you need to carry two decks. On the back of each base is one packet trick pocket. These are the same pockets that are on our Original High Caliber Holster™. The packet trick pockets can hold business cards too, so you can have your cards ready to hand out at a moment's notice. The accessory mounts are 1 inch (25mm) strap loops, and a 3/16 inch(1cm) grommet. Both the left and right base have two strap loops each; one forward and one toward the rear. You can use these mounts to hang your existing pouches or loads at the edge of your jacket, right where you need them. There is also one grommet in the center of the back strap, so you can hang a load in the small of your back with all the weight on your shoulders instead of tearing your jacket lining. The Derringer™ is a must have for light carry work. But using the accessory mounts, it can really be used to hold a lot more than any light carry situation would call for. This design allows you to take what you need, without all the hassle of what you don't. |
Home | Apparatus | About Us | Contact | FAQ